Grandstream Networks BudgeTone-200 Bedienungsanleitung PDF herunterladen (Seite 16)

Grandstream Networks, Inc. BT200 User Manual Page 16 of 33

Firmware 1.1.5.15 Last Updated: 01/2008

Answer an Incoming Call

There are two ways to answer an incoming call:

1. Pick up the handset to answer the call normally using handset, or

2. Press the SPEAKERPHONE button to answer in speakerphone or headset mode

Call Hold

While in conversation, pressing the “Hold” button will put the remote end on hold. Pressing the “Hold”

button again will release the previously Hold state and resume the bi-directional media.

Call Waiting and Call Flashing

If call waiting feature is enabled, while the user is in a conversation, he will hear a special stutter tone if

there is another incoming call. User then can press FLASH button to put the current call party on hold

automatically and switch to the other call. Pressing flash button toggles between two active calls.

Call Transfer

Two transfer operations are supported.

BLIND TRANSFER

User can transfer an active call to a third party without announcement.

User presses the “TRANSFER” button and if the other voice channel is available (i.e., there is no

other active conversation besides the current one), user will hear a dial tone. User can then dial the

third party’s phone number followed by pressing SEND button.

NOTE:

• “Enable Call Feature” has to be configured to “Yes” in web configuration page in order to make

the features to work.

A can hold on to the phone and wait for one of the three following behaviors:

• A quick confirmation tone (temporarily using the call waiting indication tone) follows by a

dial tone. This indicates the transfer has been successful. At this point, the user can either hang

up or make another call.

• A quick busy tone followed by a restored call (On supported platforms only). This means the

transfer has failed due to the failed response sent from server and the phone will try to recover

the call. The busy tone is just to indicate to the transferor that the transfer has failed.

• Busy tone keeps playing. This means the phone has failed to receive the final response and

decide to time out. Be advised that this does not indicate the transfer has been successful, nor

does it indicate the transfer has failed.

ATTENDED TRANSFER

User can transfer an active call to a third party with announcement.

User presses the “FLASH” button and hears a dial tone, then dial the third party’s phone number

followed by pressing “SEND” button. If the call is answered, press “TRANSFER” to complete the

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Keine Kommentare

Grandstream Networks BudgeTone-200 Bedienungsanleitung Seite 16