Grandstream Networks GXW400x Bedienungsanleitung PDF herunterladen (Seite 27)

Grandstream Networks, Inc. GXW-400x User Manual Page 27 of 31

Firmware 1.0.0.17 Last Updated: 12/2006

Directions For Downloading TFTP Server:

1. Unzip the file and put all of the files under the root directory of the TFTP server.

2. Put the PC running the TFTP server and the GXW–400x in the same LAN segment.

3. Go to File -> Configure -> Security to change the TFTP server's default setting from "Receive

Only" to "Transmit Only" for the firmware

upgrade.

4. Start the TFTP server, in the phone’s web configuration page.

5. Configure the Firmware Server Path with the IP address of the PC.

6. Update the change and reboot the unit.

You can also download the free HTTP server from

http://httpd.apache.org/ or just use Microsoft IIS web

RESTORE FACTORY DEFAULT SETTING

WARNING! Restoring the Factory Default Setting will DELETE all configuration information of the phone.

Please BACKUP or PRINT out all the settings before you approach to following steps. Grandstream will

not take any responsibility if you lose all the parameters of setting and cannot connect to your VoIP

service provider.

FACTORY RESET

The only way to reset default factory settings is to follows these four (4) steps:

1. Unplug the Ethernet cable.

2. Locate a needle-sized hole on the back panel of the gateway unit

next to the power

connection.

3. Insert a pin in this hole, and press for about 7 seconds.

4. Take out the pin. All unit settings are restored to factory settings.

1 2 ... 22 23 24 25 26 27 28 29 30 31

Keine Kommentare

Grandstream Networks GXW400x Bedienungsanleitung Seite 27